Mix surface adhesive in a ratio of 1/100 with cold water (a smaller amount of water increases the adhesive effect), stir vigorously again after 30 minutes. The contact agent is now ready for use, apply with a brush to a surface that is ready for installation, i.e. tensile and pressure-resistant, permanently dry, crack-free, dust-free and particle-free, clean, non-impregnated surface, do not process the object or room temperature below +15 °C. Before use, test in an inconspicuous area first to ensure material compatibility! Place the hammer-proof profile, apply it firmly and let it dry for approx. 120 to 180 minutes. Do not walk on it during the drying phase - risk of accident! Profile can now be walked on. After completing the protective measure, pull it off with a hammer, clean the surface with a wet cloth and wipe dry. The ONP ensures safe access and lasting protection of the covered surface in a short time on stairs, edges, ledges, small and large sensitive surfaces. ONP is water-soluble, so in order to avoid accidents, the adhesion and walkability must be checked before access. In order to achieve optimal adhesion, we recommend carrying out a test bonding with the substrate due to the different properties of different surfaces!!!
